Disassembly and assembly

ManualsBrandsPerkins Engine ManualsOther854F-E34T, 854E-E34TA, 854F-E34TA Disassembly and Assembly

100

6. Tighten bolts (3) to a torque of 25 N·m (221 lb in)

in sequence that is shown in Illustration 155 .

7. Position bracket (9) onto engine oil cooler (3).

Install bolt (8) to bracket (9). Tighten the bolt to a

torque of 15 N·m (133 lb in).

8. Install boost pressure chamber cover (4). Refer to

Disassembly and Assembly, “Turbocharger -

Install” for the correct procedure.

9. If necessary, install the turbo charger oil drain tube

assembly. Refer to Disassembly and Assembly,

“Turbocharger - Install” for the correct procedure.

10. Install a new O-ring seal (7) (not shown) to tube

assembly (5).

11. Install tube assembly (5) to engine oil cooler (3).

12. Install bolts (6) to tube assembly (5). Tighten the

bolts to a torque of 25 N·m (221 lb in).

13. Connect the coolant hoses to tube assembly (5).

14. Install the Alternator. Refer to Disassembly and

Assembly, “Alternator - Install” for the correct

procedure.

15. Fill the cooling system to the correct level. Refer

to Operation and Maintenance Manual, “Cooling

System Coolant - Change” for the correct

procedure.

16. If the engine oil was drained during the engine oil

cooler removal procedure, refill the lubrication

system. Refer to Operation and Maintenance

Manual, “Engine Oil and Filter - Change” for the

correct procedure.

17. Check the level of the engine lubricating oil. Refer

to Operation and Maintenance Manual, “Engine

Oil Level - Check” for the correct procedure.

i05270776

Engine Oil Relief Valve -

Remove and Install

Removal Procedure

Illustration 157 g02953956

1. Remove bolts (2) from engine oil relief valve (1).

2. Remove engine oil relief valve (1) from the cylinder

block.

3. Remove O-ring seal (3) from engine oil relief valve

(1).

Installation Procedure

NOTICE

Keep all parts clean from contaminants.

Contaminants may cause rapid wear and shortened

component life.

1. Check all components for wear and damage. If

necessary, replace any components that are worn

or damaged.

92 UENR0624-03

Disassembly and Assembly Section

This document has been printed from SPI2. NOT FOR RESALE