Disassembly and assembly

c. Remove gaskets (11).
i05270774
Engine Oil Cooler - Install
Installation Procedure
1. Ensure that all components are free from wear and
damaged. If necessary, replace any components
that are worn or damaged.
Illustration 154 g02707318
2. If necessary, follow Step 2.a through Step 2.d in
order to assembly the engine oil cooler.
a. Ensure that engine oil cooler matrix (12) is
clean, free from damage and restriction.
Replace engine oil cooler matrix (12) if
damaged or restricted.
b. Ensure that housing (10) is clean and free from
damage. Replace housing (10) if damaged.
c. Position new gaskets (11) onto engine oil cooler
matrix (12). Install engine oil cooler matrix (12)
to housing (10).
d. Install bolts (13) and bolts (14) to the assembly
of oil cooler (3). Tighten bolts (13) and bolts (14)
to a torque of 25 N·m (221 lb in).
Illustration 155 g02871598
Tightening sequence for the engine oil cooler.
Illustration 156 g02706998
3. Clean the gasket surfaces of the cylinder block.
4. Position a new gasket (4) onto the engine oil
cooler.
5. Install assembly of engine oil cooler (5) to the
cylinder block. Install bolts (1) to the assembly of
oil cooler (3).
Note: Ensure that the bolts of different lengths are
installed in the correct position.
UENR0624-03 91
Disassembly and Assembly Section
This document has been printed from SPI2. NOT FOR RESALE