Disassembly and assembly

Installation Procedure
Table 27
Required Tools
Tool Part Number
Part Description Qty
A
T400083
Filter Cartridge Tool
1
NOTICE
Keep all parts clean from contaminants.
Contaminants may cause rapid wear and shortened
component life.
Illustration 150 g02675998
Typical example
1. Clean the gasket surface of the engine oil filter
base (4). Clean the gasket surface of the cylinder
block.
2. If necessary, install new O-ring seal (8) (not
shown) to plug (9). Install plug (9) to engine oil
filter base (1). Tighten the plug to a torque of
30 N·m (266 lb in).
3. If necessary, install new plug (10) to engine oil filter
base (4). Tighten the plug to a torque of 30 N·m
(266 lb in).
4. If necessary, install new plug (11) to engine oil filter
base (4). Tighten the plug to a torque of 10 N·m
(89 lb in).
5. If necessary, install new plug (2) to engine oil filter
base (4). Tighten the plug to a torque of 30 N·m
(266 lb in).
6. Position new gasket (5) (not shown) onto engine
oil filter base (4). Install bolts (6) to engine oil filter
base (4).
Note: Ensure that the different length bolts are
installed in the correct position.
7. Install the assembly of the engine oil filter base to
the cylinder block. Tighten bolts (6) to a torque of
25 N·m (221 lb in).
8. If necessary, install the engine oil pressure switch.
Refer to Disassembly and Assembly, “Engine Oil
Pressure Switch - Remove and Install” for the
correct procedure.
9. Connect wiring harness assembly (1) to engine oil
pressure switch (3).
10. Use Tooling (A) in order to install new engine oil
filter (7). Refer to Operation and Maintenance
Manual, “Engine Oil and Filter - Change” for the
correct procedure.
11. Check the level of the engine oil. Refer to
Operation and Maintenance Manual, “Engine Oil
Level - Check” for the correct procedure.
i05270773
Engine Oil Cooler - Remove
Removal Procedure
Start By:
a. Remove the alternator and mounting bracket.
Refer to Disassembly and Assembly,
“Alternator - Remove” for the correct
procedure.
NOTICE
Keep all parts clean from contaminants.
Contaminants may cause rapid wear and shortened
component life.
NOTICE
Care must be taken to ensure that fluids are con-
tained during performance of inspection, mainte-
nance, testing, adjusting and repair of the product.
Be prepared to collect the fluid with suitable contain-
ers before opening any compartment or disassem-
bling any component containing fluids.
Dispose of all fluids according to local regulations
and mandates.
UENR0624-03 89
Disassembly and Assembly Section
This document has been printed from SPI2. NOT FOR RESALE