Disassembly and assembly

End By:
a. Install the inlet valves and the exhaust valves.
Refer to Disassembly and Assembly , “Inlet
and Exhaust Valves - Remove and Install”.
i05270770
Engine Oil Filter Base -
Remove and Install
Removal Procedure
Table 26
Required Tools
Tool Part Number
Part Description Qty
A
T400083
Filter Cartridge Tool
1
NOTICE
Keep all parts clean from contaminants.
Contaminants may cause rapid wear and shortened
component life.
NOTICE
Care must be taken to ensure that fluids are con-
tained during performance of inspection, mainte-
nance, testing, adjusting and repair of the product.
Be prepared to collect the fluid with suitable contain-
ers before opening any compartment or disassem-
bling any component containing fluids.
Dispose of all fluids according to local regulations
and mandates.
Illustration 149 g02675998
Typical example
1. Disconnect wiring harness assembly (1) from
engine oil pressure switch (3).
2. Place a suitable container below engine oil filter (7)
in order to catch any oil that might be spilled.
3. Use Tooling (A) in order to remove engine oil filter
(7). Refer to Operation and Maintenance Manual,
“Engine Oil and Filter - Change” for the correct
procedure.
4. Remove bolts (6) from oil filter base (1).
Note: Note the position of the different length bolts
for installation purposes.
5. Remove engine oil filter base (4) from the cylinder
block.
6. Remove gasket (5) (not shown).
7. If necessary, remove plug (2) from engine oil filter
base (4).
8. If necessary, remove plug (11) from engine oil filter
base (4).
9. If necessary, remove plug (10) from engine oil filter
base (4).
10. If necessary, remove plug (9) from engine oil filter
base (1). Remove O-ring seal (8) (not shown) from
plug (9).
11. If necessary, remove the engine oil pressure
switch. Refer to Disassembly and Assembly,
“Engine Oil Pressure Switch - Remove and
Install”.
88 UENR0624-03
Disassembly and Assembly Section
This document has been printed from SPI2. NOT FOR RESALE