Disassembly and assembly

Illustration 136 g02922816
Illustration 137 g02922879
3. If necessary, install studs (4) into inlet manifold (6).
Tighten the studs to a torque of 5 N·m (44 lb in).
4. If necessary, install diffuser (5) into inlet manifold
(6).
5. Install Tooling (A) in Positions (X) in adaptor plate
assembly (10). Refer to Illustration 135 .
6. Position new gasket (8) onto Tooling (A).
7. Install inlet manifold (6) onto Tooling (A).
8. Position bracket (2) onto inlet manifold (6) and
install bolt (7) finger tight.
9. Position tube and bracket assembly (13) onto inlet
manifold (6) and install bolt (7) finger tight.
10. Install sealing washers (14) (not shown) and
banjo bolt (15) to tube and bracket assembly (13).
Refer to Disassembly and Assembly, “Pressure
Sensor (Exhaust Back Pressure) - Remove and
Install” for the correct procedure.
11. Position bracket (12) onto inlet manifold (6) and
install bolt (7) finger tight. Connect tube and
bracket assembly (13 ) onto bracket (12). Refer to
Disassembly and Assembly, “Pressure Sensor
(Exhaust Back Pressure) - Remove and Install” for
the correct procedure.
12. Remove Tooling (A).
13. Install remaining bolts (7) in available positions.
Illustration 138 g02924860
Illustration 139 g02924916
14. Tighten bolts (7) in the sequence that is shown in
Illustration 138 to a torque of 27 N·m (239 lb in).
80 UENR0624-03
Disassembly and Assembly Section
This document has been printed from SPI2. NOT FOR RESALE