Disassembly and assembly

7. If necessary, remove diffuser (5) from inlet
manifold (6).
8. If necessary, follow Step 8.a through Step 8.d in
order to remove adaptor plate (10).
a. Remove the electronic unit injectors. Refer to
Disassembly and Assembly, “Electronic Unit
Injector - Remove” for the correct procedure.
b. Remove bolts (9) from adaptor plate (10).
c. Remove adaptor plate (10) from the cylinder
head.
d. Remove O-ring seals (11) (not shown).
Installation Procedure
Table 19
Required Tools
Tool Part Number
Part Description Qty
A
-
Guide Stud
M8 x 1.25mm by 90mm
2
NOTICE
Keep all parts clean from contaminants.
Contaminants may cause rapid wear and shortened
component life.
NOTICE
Remove the plugs that were installed during the dis-
assembly procedure prior to installing components.
Care must be taken to ensure that loose parts and
debris do not enter the engine.
1. Clean all gasket surfaces.
Illustration 134 g02921858
Illustration 135 g02922116
2. If necessary, follow Step 2.a through Step 2.d in
order to install adaptor plate (10).
a. Install new O-ring seals (11) into adaptor plate
(10).
b. Position adaptor plate assembly (10) onto the
cylinder head.
c. Install bolts (9) finger tight. Tighten the bolts
evenly in the sequence that is shown in
Illustration 135 to a torque of 25 N·m (221 lb in).
d. Install the electronic unit injectors. Refer to
Disassembly and Assembly, “Electronic Unit
Injector - Install” for the correct procedure.
UENR0624-03 79
Disassembly and Assembly Section
This document has been printed from SPI2. NOT FOR RESALE