Disassembly and assembly

CEM Assembly installation
Procedure
Illustration 127 g03017437
1. Position bracket (2) and loosely install bolts (3).
Position bracket (4) and loosely install bolts (5).
2. Using temporary marks, align bracket (2) and
tighten bolts (3) to a torque of 25 N·m (221 lb in)
3. Using temporary marks, align bracket (4) and
tighten bolts (5) to a torque of 25 N·m (221 lb in)
End By:
a. Install the DPF. Refer to Disassembly and
Assembly, “Diesel Particulate Filter - Install ”
for the correct procedure.
i05270751
Support and Mounting (CEM) -
Remove and Install
(Option 1)
CEM Assembly Removal
Procedure
Start By:
a. Remove the DPF. Refer to Disassembly and
Assembly, “Diesel Particulate Filter - Remove ”
for the correct procedure.
Illustration 128 g03013176
Typical example
Make temporary marks on all components on the
support assembly (1) and all bolts, in order to aide
alignment during installation.
76 UENR0624-03
Disassembly and Assembly Section
This document has been printed from SPI2. NOT FOR RESALE