Disassembly and assembly

4. Using temporary marks align assembly (1) and

tighten the bolts.

5. If necessary, tighten bolts (4) to a torque of 25 N·m

(221 lb in).

6. If necessary, tighten bolts (8) to a torque of 25 N·m

(221 lb in).

7. Tighten bolts (6) to a torque of 25 N·m (221 lb in).

8. Tighten bolts (7) to a torque of 25 N·m (221 lb in).

9. Tighten bolts (3) to a torque of 45 N·m (33 lb ft).

End By:

a. Install the DPF. Refer to Disassembly and

Assembly, “Diesel Particulate Filter - Install ”

for the correct procedure.

i05270728

Support and Mounting (CEM) -

Remove and Install

(Option 2)

CEM Assembly Removal

Procedure

Start By:

a. Remove the DPF. Refer to Disassembly and

Assembly, “Diesel Particulate Filter - Remove ”

for the correct procedure.

Illustration 126 g03017437

Make temporary marks on all components on both

support assemblies (1) and all bolts, in order to aide

alignment during installation.

1. Remove bolts (3) from bracket (2) and remove

bracket (2) from the engine.

2. Remove bolts (5) from bracket (4) and remove

bracket (4) from the engine.

UENR0624-03

Disassembly and Assembly Section

This document has been printed from SPI2. NOT FOR RESALE