Disassembly and assembly

Note: Do not start the engine with the bellows
protector in place.
17. Connect the wiring harness assembly to
connection (1) on temperature sensor (2).
18. Connect the wiring harness assembly to
connection (11) on temperature sensor (3).
19. Connect the pressure sensor tube assembly (9)
to the DPF. Tighten the connection to a torque of
30 N·m (265 lb in).
20. Connect the pressure sensor tube assembly (7)
to the DPF. Tighten the connection to a torque of
30 N·m (265 lb in).
End By:
a. If the DPF has had an ash service, it will be
necessary to use the electronic service tool in
order to perform the ““DPF Ash Cleaning””
procedure.
b. If the DPF required replacing and a new DPF
has been installed, it will be necessary to use
the electronic service tool in order to perform
the ““DPF Replacement Reset”” procedure.
i05270725
Support and Mounting (CEM) -
Remove and Install
(Option 3)
CEM Assembly Removal
Procedure
Start By:
a. Remove the DPF. Refer to Disassembly and
Assembly, “Diesel Particulate Filter - Remove ”
for the correct procedure.
Illustration 122 g03019496
Make temporary marks on all components on support
assemblies (1) and all bolts, in order to aide
alignment during installation.
UENR0624-03 73
Disassembly and Assembly Section
This document has been printed from SPI2. NOT FOR RESALE