Disassembly and assembly

Illustration 117 g03017439
Illustration 118 g03017436
Illustration 119 g03022697
3. If necessary, install the temperature sensors (3)
and temperature sensor (9) into the DPF. Refer to
Disassembly and Assembly, “Temperature Sensor
(DPF) - Remove and Install” for the correct
procedure.
4. Position a new V-band clamp onto flexible exhaust
pipe (8).
5. Attach a suitable lifting device to the assembly of
the Diesel Particulate Filter (DPF) (6). The weight
of the DPF is approximately 15 kg (33 lb).
6. Use the suitable lifting device in order to install the
DPF to mounting bracket (12). Ensure that the
flexible exhaust pipe is correctly seated onto the
turbocharger and DPF with the alignment pin (13)
(not shown) fully engaged.
Note: Ensure that the exhaust gases flow in the
direction of temporary mark.
7. Remove the suitable lifting device from the
assembly of the DPF.
8. Position clamps (11) onto DPF (6). Loosely install
bolts (10).
9. Loosely install the Original Equipment
Manufacturer's (OEM) exhaust pipe assembly to
outlet section (4) of the DPF.
10. Align the temporary alignment marks on DPF (6)
and clamps (11) in Positions (A), (B), (C) and (D).
Note: Ensure that the flexible exhaust pipe bellows
are not subjected to any undue stress.
70 UENR0624-03
Disassembly and Assembly Section
This document has been printed from SPI2. NOT FOR RESALE