Disassembly and assembly

Installation Procedure
1. Ensure that the exhaust manifold is clean and free
from damage. If necessary, replace the exhaust
manifold. Clean the gasket surface of the cylinder
head.
Illustration 110 g02725206
Illustration 111 g02725251
2. If necessary, install studs (2) to exhaust manifold
(3). Tighten the stud to a torque of 18 N·m
(159 lb in).
3. Position a new exhaust manifold gasket (6) (not
shown) onto studs (4).
Note: Ensure that the exhaust manifold gasket is
correctly oriented.
4. Position exhaust manifold (3) onto studs (4).
5. Install nuts (5) to studs (4) finger tight. Tighten the
nuts in the sequence that is shown in Illustration
111 in two stages.
UENR0624-03 65
Disassembly and Assembly Section
This document has been printed from SPI2. NOT FOR RESALE