Disassembly and assembly

Illustration 109 g02725251
Tighten sequence of exhaust manifold
1. Remove tube assembly (1). Refer to Disassembly
and Assembly, “Air Control Valve - Remove and
Install” for the correct procedure.
2. Loosen nuts (5) in reverse numerical order. Refer
to Illustration 109 .
Note: Loosening the bolts in reverse numerical order
will help prevent distortion of the exhaust manifold.
3. Remove nuts (5) and remove exhaust manifold (3)
from the cylinder head.
4. Remove exhaust manifold gasket (6) (not shown).
5. If necessary, remove studs (2) from the exhaust
manifold.
6. If necessary, remove studs (4) from the cylinder
head.
64 UENR0624-03
Disassembly and Assembly Section
This document has been printed from SPI2. NOT FOR RESALE