Disassembly and assembly

Note: Care should be taken when handling the lines
group. The slightest bump or drop can result in a
misalignment of the bellows and a possible need for
replacement.
5. Discard clamp assemblies (2) and (6). The clamp
assemblies are a one time use part.
Note: Steps 6 through 7 are only necessary if clamp
(4) was loosened to remove the entire lines group.
Illustration 3 g02231056
Typical example
(7) Weld
6. Remove clamp (4) from bellows (5) by removing
weld (7). Use a grinding device to remove the spot
weld.
Note: Use care not to remove excessive amounts of
material and grind on the bellows.
Note: Do not use a vice to secure the lines group.
The bellows cannot be damaged in any way during
this procedure.
Note: Use the proper personal protective equipment
when removing clamp (4) from the bellows assembly.
Illustration 4 g02231059
Typical example
Remove the weld from the bellows assembly with a
grinding device
7. Inspect the clamping surface on the outside of the
bellows. Deburr the surface if necessary.
Note: If the bellows assembly is damaged during the
removal of clamp (4), replace the bellows assembly.
Installation
Note: Step 1 is only necessary if clamp (4) was
loosened to remove the entire lines group.
6 UENR0624-03
Disassembly and Assembly Section
This document has been printed from SPI2. NOT FOR RESALE