Disassembly and assembly

Illustration 93 g02721016
Illustration 94 g02720973
2. If necessary, position bracket (10) onto the water
temperature regulator housing. Ensure that the
bracket is correctly located onto the spigot in
Position (A).
3. Install bolt (11) and tighten the bolt to a torque of
10 N·m (89 lb in).
4. Position wastegate solenoid (5) onto bracket (10).
Install Allen head bolts (1) to wastegate solenoid
(5). Tighten Allen head bolts (1) to a torque of
10 N·m (89 lb in).
5. Position hose (8) onto the wastegate solenoid.
Tighten hose clamp (9) securely.
6. Position hose (7) onto the wastegate solenoid.
Tighten hose clamp (6) securely.
7. Position hose (3) onto the wastegate solenoid.
Tighten hose clamp (2) securely.
8. Ensure that the hoses do not come into contact
with any other engine components.
9. Connect harness assembly (4) to the wastegate
solenoid.
End By:
a. Turn the battery disconnect switch to the ON
position.
i05291333
Exhaust Gas Recirculation
Valve - Remove and Install
Removal Procedure
Start By:
a. Drain the coolant from the cooling system into
a suitable container for storage or disposal.
Refer to Operation and Maintenance Manual,
“Cooling System Coolant - Change” for the
correct procedure.
Sulfuric Acid Burn Hazard may cause serious
personal injury or death.
The exhaust gas cooler may contain a small
amount of sulfuric acid. The use of fuel with sul-
fur levels greater than 15 ppm may increase the
amount of sulfuric acid formed. The sulfuric acid
may spill from the cooler during service of the en-
gine. The sulfuric acid will burn the eyes, skin
and clothing on contact. Always wear the appro-
priate personal protective equipment (PPE) that
is noted on a material safety data sheet (MSDS)
for sulfuric acid. Always follow the directions for
first aid that are noted on a material safety data
sheet (MSDS) for sulfuric acid.
NOTICE
Keep all parts clean from contaminants.
Contaminants may cause rapid wear and shortened
component life.
UENR0624-03
55
Disassembly and Assembly Section
This document has been printed from SPI2. NOT FOR RESALE