Disassembly and assembly

20. Install the flexible exhaust pipe to the
turbocharger. Refer to Disassembly and
Assembly, “Flexible Exhaust Pipe - Remove and
Install” for the correct procedure.
i05270685
Wastegate Solenoid - Remove
and Install
Removal Procedure
Start By:
a. Turn the battery disconnect switch to the OFF
position.
Illustration 91 g02720973
Illustration 92 g02720986
1. Disconnect harness assembly (4) from wastegate
solenoid (5).
2. Place temporary marks on all hose assemblies in
order to identify the position on the wastegate
regulator (5).
3. Remove hose clamp (2). Disconnect hose
assembly (3) from wastegate solenoid (5).
4. Remove hose clamp (6). Disconnect hose
assembly (7) from wastegate solenoid (5).
5. Remove hose clamp (9). Disconnect hose
assembly (8) from wastegate solenoid (5).
6. Remove Allen head bolts (1) and remove the
wastegate solenoid from bracket (10).
7. If necessary, remove bolt (11) and remove bracket
(10) from the water temperature regulator housing.
Installation Procedure
1. Ensure that all components of wastegate regulator
are clean and free from wear and damage. If
necessary, replace the wastegate regulator as an
assembly if any of the components are worn or
damaged.
54 UENR0624-03
Disassembly and Assembly Section
This document has been printed from SPI2. NOT FOR RESALE