Disassembly and assembly

Illustration 87 g02862480
4. Clean the gasket surfaces of exhaust manifold
(19). If necessary, install studs (17) to exhaust
manifold (19) and turbocharger (11). Tighten the
studs to a torque of 15 N·m (133 lb in).
5. Position a new gasket (20) (not shown) onto
turbocharger (11).
6. Position turbocharger (11) onto exhaust manifold
(19) and install washers (16) and new nuts (15).
Tighten the nuts to a torque of 28 N·m (248 lb in).
Note: Do not use the actuator rod to lift the
turbocharger.
Illustration 88 g02859585
Illustration 89 g02859796
7. If necessary install new O-ring seals (8) onto tube
assembly (9). Install tube assembly (9) into the
cylinder block.
8. Position a new gasket (7) (not shown) onto tube
assembly (9).
9. Position tube assembly (9) onto the turbocharger.
Install bolts (10) to tube assembly (9). Tighten the
bolts to a torque of 10 N·m (89 lb in).
52 UENR0624-03
Disassembly and Assembly Section
This document has been printed from SPI2. NOT FOR RESALE