Disassembly and assembly

c. Install a new sealing washer (31) to banjo bolt
(32). Install the banjo bolt assembly to hose
assembly (26) and install the remaining sealing
washer (31). Install hose assembly (26) to boost
pressure chamber cover (33) finger tight.
d. Install tube assembly (26) into clip (25).
e. Install a new sealing washer (29) to banjo bolt
(28). Install the banjo bolt assembly to hose
assembly (8) and install the remaining sealing
washer (28). Install hose assembly (8) to boost
pressure chamber cover (33) finger tight.
f. Install the alternator and mounting bracket.
Refer to Disassembly and Assembly, “Alternator
- Remove and Install” for the correct procedure.
Illustration 83 g02868099
Illustration 84 g02719524
3. Test the turbocharger actuator for correct
operation. Refer to Systems Operation, Testing
and Adjusting, “Turbocharger - Inspect” for more
information. If the actuator is damaged or the
actuator does not operate within the specified
limits, the complete turbocharger must be
replaced.
4. If necessary, follow Step 4 through Step 5 in order
to install tube assembly (9).
a. Install new O-ring seal (19) (not shown) to tube
assembly (9).
UENR0624-03 49
Disassembly and Assembly Section
This document has been printed from SPI2. NOT FOR RESALE