Disassembly and assembly

Illustration 81 g02862040
13. If necessary, follow Step 13.a through Step 13.f in
order to remove boost pressure chamber cover
(29).
a. Remove the alternator and mounting bracket.
Refer to Disassembly and Assembly, “Alternator
- Remove and Install” for the correct procedure.
b. Remove banjo bolt (24) and remove sealing
washers (25) (not shown) from hose assembly
(6).
c. Remove banjo bolt (28) and remove sealing
washers (27) (not shown) from hose assembly
(22).
d. Release the tube assembly (22) from clip (21)
and position the hose assembly away from
boost pressure chamber cover (29).
e. Remove bolts (26) and remove boost pressure
chamber cover (29) from the oil cooler.
f. Remove gasket (23) (not shown).
i05270677
Turbocharger - Install
(Top Mounted Turbochargers)
Installation Procedure
NOTICE
Keep all parts clean from contaminants.
Contaminants may cause rapid wear and shortened
component life.
1. Ensure that the turbocharger is clean and free from
damage. Inspect the turbocharger for wear. Refer
to Systems Operation, Testing and Adjusting,
“Turbocharger - Inspect” for more information. If
the turbocharger is worn, the complete
turbocharger must be replaced.
Illustration 82 g02868256
2. If necessary, follow Step 2.a through Step 2.f in
order to remove boost pressure chamber cover
(33).
a. Position gasket (27) (not shown) onto boost
pressure chamber cover (33).
b. Position boost pressure chamber cover onto
the engine oil cooler and install bolts (30).
Tighten the bolts to a torque of 10 N·m (89 lb in)
48 UENR0624-03
Disassembly and Assembly Section
This document has been printed from SPI2. NOT FOR RESALE