Disassembly and assembly

Illustration 73 g02706897
15. Install a new O-ring seal (7) to the connection on
hose assembly (2).
16. Install hose assembly (2) to electronic unit
injector (3).
17. Install clip (1) to electronic unit injector (3).
18. If necessary, repeat Step 15 through Step 17 in
order to connect the remaining hose assemblies
(2).
19. Connect wiring harness assemblies (5) to the
electronic unit injectors. Slide the locking tab into
the locked position
20. If necessary install the exhaust gas recirculation
valve. Refer to Disassembly and Assembly,
“Exhaust Gas Recirculation Valve - Remove and
Install” for the correct procedure.
21. If necessary install the diesel particulate filter
supporting bracket. Refer to Disassembly and
Assembly, “Support and Mounting (CEM) -
Remove and Install” for the correct procedure.
22. Install the wiring harness assembly. Refer to
Disassembly and Assembly, “Fuel Injection Lines -
Install” for the correct procedure.
23. Replace the primary fuel filter. Refer to Operation
and Maintenance Manual, “Fuel System Primary
(Water Separator) Element - Replace” for the
correct procedure.
24. Replace the secondary fuel filter. Refer to
Operation and Maintenance Manual, “Fuel System
Secondary Filter - Replace” for the correct
procedure.
25. Turn the fuel supply to the ON position.
26. Turn the battery disconnect switch to the ON
position.
27. Remove the air from the fuel system. Refer to
Operation and Maintenance Manual, “Fuel System
- Prime” for the correct procedure.
i05270673
Turbocharger - Remove
(Top Mounted Turbochargers)
Removal Procedure
Start By:
a. Remove the flexible exhaust pipe from the
turbocharger. Refer to Disassembly and
Assembly, “Flexible Exhaust Pipe - Remove
and Install” for the correct procedure.
NOTICE
Keep all parts clean from contaminants.
Contaminants may cause rapid wear and shortened
component life.
NOTICE
Care must be taken to ensure that fluids are con-
tained during performance of inspection, mainte-
nance, testing, adjusting and repair of the product.
Be prepared to collect the fluid with suitable contain-
ers before opening any compartment or disassem-
bling any component containing fluids.
Dispose of all fluids according to local regulations
and mandates.
44 UENR0624-03
Disassembly and Assembly Section
This document has been printed from SPI2. NOT FOR RESALE