Disassembly and assembly

Illustration 59 g02709476
Fuel injection pump viewed from the rear
13. Remove nuts (8) from fuel injection pump (6).
Note: The fuel injection pump should be supported
by hand as the nuts are removed.
14. Carefully remove the fuel injection pump from
front housing (10).
15. Remove O-ring (11) (not shown) from the fuel
injection pump.
16. If necessary, remove studs (9) from front housing
(10).
i05500629
Fuel Injection Pump - Install
Installation Procedure
NOTICE
Ensure that all adjustments and repairs that are
carried out to the fuel system are performed by
authorized personnel that have the correct
training.
Before beginning ANY work on the fuel system,
refer to Operation and Maintenance Manual,
“General Hazard Information and High Pressure
Fuel Lines” for safety information.
Refer to System Operation, Testing and Adjust-
ing, “Cleanliness of Fuel System Components”
for detailed information on the standards of
cleanliness that must be observed during ALL
work on the fuel system.
NOTICE
Ensure that the wiring harness assembly is correctly
routed and the cable straps are not over tightened.
Over tightening of the cable straps will damage the
wiring harness convoluting.
36 UENR0624-03
Disassembly and Assembly Section
This document has been printed from SPI2. NOT FOR RESALE