Disassembly and assembly

Illustration 55 g02909198
Illustration 56 g02909137
2. If necessary, install studs (13). Refer to
Disassembly and Assembly, “Inlet Manifold -
Remove and Install” for the correct procedure.
3. Install gasket (14) (not shown) onto studs (13).
4. If necessary, follow Step 4.a through Step 4.b in
order to install adaptor (11).
a. Install new sealing washer (10) to adaptor (11).
b. Apply Tooling (A) to adaptor (11). Install adaptor
assembly (11) to air inlet elbow (3). Tighten the
adaptor to a torque of 20 N·m (177 lb in).
5. Install throttle valve (2) onto studs (13).
6. Install gasket (12) onto studs (13).
Illustration 57 g02909057
7. Install bolt (8) in Position (X) to elbow (3). Install
elbow (3) onto studs (13) and tighten bolt (8) in
Position (X) finger tight. Install remaining bolt (8).
8. Install nuts (9) to studs (13).
9. Tighten bolts (8) and nuts (9) to a torque of 10 N·m
(89 lb in).
10. Install new sealing washer (5) (not shown) to plug
(4).
11. Apply Tooling (A) to plug (4) and install the plug to
air inlet elbow (3). Tighten the plug to a torque of
50 N·m (37 lb ft).
12. Install the clamp to the air inlet hose and connect
the air inlet hose to air inlet elbow (3).
13. Connect harness assembly (1) onto throttle valve
(2). Slide the locking tab into the locked position.
i05268296
Fuel Injection Pump - Remove
Removal Procedure
Table 10
Required Tools
Tool Part Number
Part Description Qty
A
T412504
Capping Kit
1
34 UENR0624-03
Disassembly and Assembly Section
This document has been printed from SPI2. NOT FOR RESALE