Disassembly and assembly

Illustration 53 g02909137

Illustration 54 g02909198

5. Remove nuts (9) from studs (13).

6. Remove bolts (8).

Note: Bolt (8) in Position (X) must be removed with

air inlet elbow (3) in order to prevent the bolt from

falling into the induction system.

7. Remove gasket (12).

8. Remove throttle valve (2) from studs (13).

9. Remove gasket (14) (not shown).

10. If necessary, remove adaptor (11) and sealing

washer (10) from elbow (3).

11. If necessary, remove studs (13). Refer to

Disassembly and Assembly, “Inlet Manifold -

Remove and Install” for the correct procedure.

Installation Procedure

Table 9

Required Tools

Tool Part Number

Part Description Qty

Technologic 15

1. Check all components for wear and damage. If

necessary, replace any components that are worn

or damaged.

UENR0624-03 33

Disassembly and Assembly Section

This document has been printed from SPI2. NOT FOR RESALE