Disassembly and assembly

Illustration 51 g02906277
2. If necessary, install studs (9). Refer to
Disassembly and Assembly, “Inlet Manifold -
Remove and Install” for the correct procedure.
3. If necessary, install new sealing washer (11) to
adaptor (12) and apply Tooling (A) to the threads
of adaptor (12). Tighten the adaptor to a torque of
20 N·m (177 lb in).
4. Install gasket (10) to studs (9).
5. Install throttle valve (8) to studs (9).
6. Install gasket (6) to studs (9).
7. Install elbow (1) to studs (9).
8. Install bolts (5) finger tight.
9. Install nuts (3) finger tight.
10. Tighten bolts (5) and nuts (3) to a torque of
10 N·m (89 lb in).
11. Position hose clamp (2) onto hose assembly (4).
Install hose assembly (4) to adaptor (12) and
tighten hose clamp (2) securely.
12. Install harness assembly (7) to throttle valve (8).
Slide the locking tab into the locked position.
13. Install the clamp to the air inlet hose and connect
the air inlet hose to elbow (1).
i05268292
Throttle Valve (Intake Air) -
Remove and Install
(Side Facing Inlet Elbow)
Removal Procedure
Illustration 52 g02909057
1. Loosen the hose clamp and disconnect the hose
assembly from elbow (3).
2. Slide the locking tab into the unlocked position and
disconnect harness assembly (1) from throttle
valve (2).
3. Loosen hose clamp (6) and disconnect hose
assembly (7) from elbow (3).
4. Remove plug (4) from elbow (3). Remove sealing
washer (5) (not shown) from the plug.
32 UENR0624-03
Disassembly and Assembly Section
This document has been printed from SPI2. NOT FOR RESALE