Disassembly and assembly

End By:
a. Fill the cooling system with coolant. Refer to
Operation and Maintenance Manual, “Cooling
System Coolant - Change” for the correct
procedure.
i05268287
Throttle Valve (Intake Air) -
Remove and Install
(Rear Facing Inlet Elbow)
Removal Procedure
Illustration 46 g02906277
Illustration 47 g02906317
1. Loosen the hose clamp and disconnect the hose
assembly from elbow (1).
2. Slide the locking tab into the unlocked position and
disconnect harness assembly (7) from throttle
valve (8).
3. Loosen hose clamp (2) and disconnect hose
assembly (4) from elbow (1).
4. Remove bolts (5) and remove nuts (3) from the
elbow.
5. Remove the air inlet elbow from studs (9).
6. Remove gasket (6) (not shown).
7. Remove throttle valve (8) from studs (9).
8. Remove gasket (6) (not shown).
9. If necessary, remove studs (9). Refer to
Disassembly and Assembly, “Inlet Manifold -
Remove and Install” for the correct procedure.
30 UENR0624-03
Disassembly and Assembly Section
This document has been printed from SPI2. NOT FOR RESALE