Disassembly and assembly

Illustration 41 g02849446
Illustration 42 g02699461
Illustration 43 g02699462
13. Position bracket (19) onto the valve mechanism
cover. Install bolts (20) and tighten the bolts to a
torque of 25 N·m (221 lb in).
14. Install the fuel filter base mounting bracket (21)
(not shown). Refer to Disassembly and Assembly,
“Fuel Filter Base - Remove and Install” for the
correct procedure.
15. Position the wiring harness assembly (11) over
fuel injection lines (12).
16. Install bolt (6) to wiring harness assembly (11).
Tighten the bolt to a torque of 10 N·m (89 lb in)
17. Install cable straps (1) to the wiring harness and
brackets (25). Ensure that the cable straps meet
the Original Equipment Manufactures (OEM)
specifications.
18. Connect wiring harness assembly (9) to fuel
metering valve (10). Slide the locking tab for wiring
harness assembly (9) into the locked position.
19. Connect wiring harness assembly (14) to oil
pressure switch (13).
20. Connect wiring harness assembly (3) to pressure
sensor (2). Slide the locking tab for wiring harness
assembly (3) into the locked position.
21. Connect wiring harness assembly to fuel
temperature sensor (4). Slide the locking tab for
wiring harness assembly into the locked position.
22. Connect wiring harness assembly (15) to
crankshaft position sensor (16). Slide the locking
tab for wiring harness assembly (15) into the
locked position.
UENR0624-03 27
Disassembly and Assembly Section
This document has been printed from SPI2. NOT FOR RESALE