Disassembly and assembly

8. If necessary, cut cable straps in order to remove
the wiring harness assemblies.
9. Slide the locking tab for wiring harness assembly
(15) into the unlocked position. Disconnect wiring
harness assembly (15) from crankshaft position
sensor (16).
10. Slide the locking tab for wiring harness assembly
(17) into the unlocked position. Disconnect wiring
harness assembly (17) from camshaft position
sensor (18).
11. Slide the locking tab for wiring harness assembly
(9) into the unlocked position. Disconnect wiring
harness assembly (9) from fuel metering valve
(10).
12. Disconnect the wiring harness assembly from fuel
temperature sensor (4).
13. Remove bolt (6) from wiring harness assembly
(11).
14. Position wiring harness assembly (11) away from
fuel injection lines (12).
Illustration 36 g02848956
Illustration 37 g02683858
15. Remove fuel filter base mounting bracket (21)
(not shown). Refer to Disassembly and Assembly,
“Fuel Filter Base - Remove and Install” for the
correct procedure.
16. Remove bolt (23) from tube clamp (22). Remove
tube clamp (22) from fuel injection lines (12).
Note: Make temporary marks to identify the position
of the tube clamps.
17. Repeat Step 16 in order to remove the remaining
tube clamps.
24 UENR0624-03
Disassembly and Assembly Section
This document has been printed from SPI2. NOT FOR RESALE