Disassembly and assembly

6. Install bolt (2) and nut (1) (not shown) finger tight.
7. Install the alternator belt. Refer to Disassembly
and Assembly , “Alternator Belt - Remove and
Install” for the correct procedure.
8. Tighten the nut and bolt (2) to a torque of 50 N·m
(37 lb ft).
9. Tighten nut and bolt (5) to a torque of 50 N·m
(37 lb ft).
10. Connect the wiring harness assembly to the
alternator. Refer to Specifications, “Alternator” for
the correct torque.
11. Turn the battery disconnect switch to the ON
position.
i05284625
Electric Starting Motor -
Remove and Install
Removal Procedure
Accidental engine starting can cause injury or
death to personnel working on the equipment.
To avoid accidental engine starting, disconnect
the battery cable from the negative (−) battery ter-
minal. Completely tape all metal surfaces of the
disconnected battery cable end in order to pre-
vent contact with other metal surfaces which
could activate the engine electrical system.
Place a Do Not Operate tag at the Start/Stop
switch location to inform personnel that the
equipment is being worked on.
1. Turn the battery disconnect switch to the OFF
position.
2. Place identification marks on the harness
assembly that is connected to the electric starting
motor and the solenoid.
Illustration 361 g02844537
Typical example
3. Disconnect the harness assembly from the electric
starting motor and the solenoid.
4. Support electric starting motor (3).
5. Remove bolts (2) from electric starting motor (3).
6. Remove electric starting motor (3).
7. If a gasket is installed, remove gasket (4).
Installation Procedure
Illustration 362 g02844537
Typical example
1. If necessary, position a new gasket (4) onto
electric starting motor (3).
2. Position electric starting motor (3) onto flywheel
housing (1).
Note: Ensure that the electric starting motor is
seated correctly in the starter motor pocket.
3. Install bolts (2) to electric starting motor (3).
Tighten the bolts to a torque of 45 N·m (33 lb ft)
4. Connect the harness assembly to the electric
starting motor and the solenoid.
UENR0624-03 199
Disassembly and Assembly Section
This document has been printed from SPI2. NOT FOR RESALE