Disassembly and assembly

Illustration 358 g02815797
Illustration 359 g02673920
Illustration 360 g02815777
a. Position bracket (14) onto the cylinder block.
b. Install bolts (13) to bracket (14).
c. If necessary, install bolt (13) to the coolant tube
assembly.
d. Tighten bolts (13) to a torque of 50 N·m
(37 lb ft).
e. Position tensioner (11) onto the fan drive
assembly.
f. Install bolt (12) to tensioner (11) finger tight.
3. If necessary, follow Step 3.a through Step 3.f in
order to install pulley (8) to alternator (2).
a. Place alternator (6) in a suitable support.
b. Ensure that fan (10) is correctly oriented.
c. Install fan (10) to shaft (9).
d. Ensure that pulley (7) is correctly oriented.
e. Install pulley (7) and a new nut (8) to alternator
shaft (9).
f. Position a cranked ring spanner onto nut (9).
Use a suitable tool in order to turn the shaft of
the alternator in a counterclockwise direction.
Tighten the nut to the correct torque. Refer to
Specifications, “Alternator” for the correct
torque.
4. Position the alternator onto bracket (4) and
tensioner (11).
5. Install bolt (5) (not shown) and nut (3) finger tight.
198 UENR0624-03
Disassembly and Assembly Section
This document has been printed from SPI2. NOT FOR RESALE