Disassembly and assembly

7. If necessary, follow Step 7.a through Step 7.e in
order to remove pulley (7) from alternator (6).
Note: A suitable tool may be required in order to
carry out the removal of the alternator pulley.
a. Place the alternator in a suitable support.
b. Hold shaft (9) of alternator (6) with a suitable
tool. Use a cranked ring spanner to loosen nut
(8).
c. Make a temporary mark on pulley (7) in order to
show the correct orientation.
d. Remove nut (8) and pulley (7) from shaft (9).
e. Remove fan (10) from shaft (9).
Illustration 357 g02815797
8. If necessary, follow Step 8.a through Step 8.c in
order to remove tensioner (11) and alternator
bracket (14) from the cylinder block.
a. Remove bolt (12) and remove tensioner bracket
(11).
b. If necessary, remove bolt (14) (not shown) from
the coolant tube assembly.
c. Remove bolts (13) from alternator bracket (15).
Remove the alternator bracket from the cylinder
block.
Note: Support the weight of the alternator bracket
as the bolts are removed.
i05284624
Alternator - Install
Installation Procedure
1. Ensure that all components are clean and free
from wear and damage. If necessary, replace any
components that are worn or damaged.
2. If necessary, follow Step 2.e through Step 2.f in
order to install alternator bracket (11) onto the
cylinder block.
UENR0624-03 197
Disassembly and Assembly Section
This document has been printed from SPI2. NOT FOR RESALE