Disassembly and assembly

Illustration 349 g02710322
Typical example
1. If necessary, remove bolts (1) and remove engine
lifting bracket (2).
2. Remove bolt (4) and remove idler pulley (3).
Installation Procedure
NOTICE
Keep all parts clean from contaminants.
Contaminants may cause rapid wear and shortened
component life.
1. Ensure that all components of the idler pulley are
clean and free from wear and damage. If
necessary, replace any components that are worn
or damaged.
Illustration 350 g02710444
Typical example
2. Install bolts (4) to idler pulley (3). Position idler
pulley (3) onto the cylinder head.
3. Tighten bolt (4) to a torque of 40 N·m (30 lb ft).
4. If necessary, install bolts (1) to engine lifting
bracket (2). Position the engine lifting bracket onto
the idler pulley.
5. Tighten bolt (1) to a torque of 40 N·m (30 lb ft).
UENR0624-03 193
Disassembly and Assembly Section
This document has been printed from SPI2. NOT FOR RESALE