Disassembly and assembly

Illustration 341 g03364176
a. Loosen nut (6) on tube assembly (7).
b. Remove bolt (5) from inlet manifold temperature
sensor housing (7).
c. Disconnect tube assembly (7) from inlet
manifold temperature sensor housing (4).
d. Remove inlet manifold temperature sensor
housing (4) from inlet manifold (8).
e. Remove banjo bolt (10) and sealing washers (9)
(not shown).
f. Remove tube assembly (7).
Installation Procedure
Illustration 342 g03364176
1. If necessary, follow Step 1.a through Step 1.f in
order to install the inlet manifold temperature
sensor housing (4) and tube assembly (7).
a. Install new sealing washers (9) (not shown) and
banjo bolt (10) to tube assembly (7).
b. Position tube assembly onto induction manifold
(8) and loosely install banjo bolt (10).
c. Position inlet manifold temperature sensor
housing (4) onto inlet manifold (8). Tighten nut
(6) finger tight.
d. Install bolt (5). Tighten the bolt to a torque of
10 N·m (89 lb in).
e. Tighten nut (6) to a torque of 10 N·m (89 lb in).
f. Tighten banjo bolt (10) to a torque of 10 N·m
(89 lb in).
UENR0624-03 189
Disassembly and Assembly Section
This document has been printed from SPI2. NOT FOR RESALE