Disassembly and assembly

bracket (7). Tighten banjo bolt assembly (10)
finger tight.
d. Install bolt (1) to the bracket for tube assembly
(6).
e. Position adaptor bracket (7) onto the induction
manifold and install bolt (2).
f. Tighten nut (8) finger tight.
g. Tighten bolt (1) and bolt (2) to a torque of
25 N·m (221 lb in).
h. Tighten banjo bolt (10) to a torque of 15 N·m
(133 lb in).
i. Tighten nut (8) to a torque of 15 N·m (133 lb in).
3. Install new O-ring seal (6) (not shown) to exhaust
back pressure sensor (5).
4. Install exhaust back pressure sensor (5). Tighten
the sensor to a torque of 15 N·m (133 lb in)
5. Connect harness assembly (3) to exhaust back
pressure sensor (5) and slide the locking tab into
the locked position.
6. If necessary, install the exhaust gas temperature
sensor. Refer to Disassembly and Assembly,
“Temperature Sensor (Exhaust) - Remove and
Install” for the correct procedure.
7. If necessary, install the exhaust gas recirculation
cooler. Refer to Disassembly and Assembly,
“Exhaust Cooler (NRS) - Remove and Install” for
the correct procedure.
8. If necessary, install the diesel particulate mounting
bracket. Refer to Disassembly and Assembly,
“Support and Mounting (CEM) - Remove and
Install” for the correct procedure.
9. Install harness assembly (4) onto exhaust back
pressure sensor bracket (7).
10. Install bolt (2) to exhaust back pressure sensor
(4). Tighten the bolt to a torque of 25 N·m
(221 lb in).
i05296475
Inlet Manifold Temperature
Sensor - Remove and Install
Removal Procedure
Illustration 338 g03366344
1. Disconnect the wiring harness assembly (not
shown) from inlet manifold temperature sensor (3).
2. Remove inlet manifold temperature sensor (3)
from inlet manifold (1).
3. Remove seal (2) (not shown) from the inlet
manifold temperature sensor.
UENR0624-03 187
Disassembly and Assembly Section
This document has been printed from SPI2. NOT FOR RESALE