Disassembly and assembly

h. Remove bolt (1) from the bracket for tube
assembly (9).
i. Remove tube assembly (9) from the exhaust
manifold.
j. Remove and sealing washers (11) (not shown).
Installation Procedure
1. Check all components for wear and damage. If
necessary, replace any components that are worn
or damaged.
Illustration 336 g02915178
Illustration 337 g02917036
2. If necessary, follow Step 2.a through Step 2.i in
order to install tube assembly (6).
a. Install a new sealing washer (11) (not shown) to
banjo bolt (10).
b. Install banjo bolt assembly (10) into tube
assembly (9). Install the remaining new sealing
washer (11) (not shown) to banjo bolt assembly
(10).
c. Install tube assembly (9) onto the exhaust
manifold and exhaust back pressure sensor
186 UENR0624-03
Disassembly and Assembly Section
This document has been printed from SPI2. NOT FOR RESALE