Disassembly and assembly

5. If necessary, install the diesel particulate filter
mounting bracket. Refer to Disassembly and
Assembly, “Support and Mounting (CEM) -
Remove and Install” for the correct procedure.
i05282753
Temperature Sensor (DPF) -
Remove and Install
Removal Procedure
NOTICE
Do not strike any part of the assembly of the Diesel
Particulate Filter (DPF). Do not allow any object to
contact the internal element of the DPF. If the internal
element of the DPF becomes damaged, the assem-
bly must be replaced.
NOTICE
The temperature sensors for the Diesel Particulate
Filter (DPF) are of different lengths and should be in-
stalled in the original position.
Illustration 330 g02728556
1. Disconnect the harness assembly from connection
(1).
2. Make temporary identification marks on
temperature sensor (2) for installation purpose.
Remove the temperature sensor from Diesel
Particulate Filter (DPF) (3).
3. If necessary, repeat Step 1 through Step 2 in order
to remove the remaining temperature sensor from
the DPF.
Installation Procedure
Table 75
Required Tools
Tool Part Number
Part Description Qty
A
-
Bostik Pure Nickel
Anti-Seize Compound
1
1. Ensure that all components are clean and free
from wear and damage. If necessary, replace any
components that are worn or damaged.
Illustration 331 g02728556
2. Use tooling (A) in order to lubricate the thread of
temperature sensor (2).
3. Install temperature sensor (2) to DPF (3). Tighten
temperature sensor to a torque of 50 N·m
(37 lb ft)
Note: Ensure correct positioning of the temperature
sensor.
4. Connect harness assembly (1).
UENR0624-03 183
Disassembly and Assembly Section
This document has been printed from SPI2. NOT FOR RESALE