Disassembly and assembly

7. Turn the battery disconnect switch to the ON
position.
i05282745
Oxygen Sensor - Remove and
Install
(Catalytic Converter)
Removal Procedure
Start By:
a. Turn the battery disconnect switch to the OFF
Position.
NOTICE
Keep all parts clean from contaminants.
Contaminants may cause rapid wear and shortened
component life.
Illustration 326 g02725166
1. Disconnect harness assembly (1).
2. Remove oxygen sensor (2) from exhaust tube
assembly (3).
3. Remove sealing washer (4) from the oxygen
sensor.
Installation Procedure
Table 74
Required Tools
Tool Part Number
Part Description Qty
A
-
Bostik Pure Nickel
Anti-Seize Compound
1
NOTICE
Keep all parts clean from contaminants.
Contaminants may cause rapid wear and shortened
component life.
Illustration 327 g02725166
1. Install a new sealing washer (4) (not shown) to
oxygen sensor (2).
2. Apply Tooling (A) to the threads of oxygen sensor
(4) (not shown).
3. Install oxygen sensor (2) to exhaust tube assembly
(3). Tighten the oxygen sensor to a torque of
50 N·m (37 lb ft).
4. Connect harness assembly (1).
UENR0624-03 181
Disassembly and Assembly Section
This document has been printed from SPI2. NOT FOR RESALE