Disassembly and assembly

Illustration 324 g02876777
3. Disconnect harness assembly (3) from fuel
temperature sensor (2).
4. Use a deep socket in order to remove fuel
temperature sensor (2) from fuel filter base (1).
5. Use Tooling (A) to plug the open port of the fuel
injection pump.
6. Remove sealing washer (4) (not shown) from fuel
temperature sensor (2).
Installation Procedure
NOTICE
Keep all parts clean from contaminants.
Contaminants may cause rapid wear and shortened
component life.
1. Ensure that all components are free from wear and
damage. Replace any components that are worn
or damaged.
Illustration 325 g02876777
2. Ensure that the new sealing washer (4) (not
shown) on the fuel temperature sensor (2) is free
from damage.
3. Remove the plug from the fuel filter base (1).
4. Install fuel temperature sensor (2) to the fuel filter
base. Use a deep socket to tighten the fuel
temperature sensor to a torque of 22 N·m
(195 lb in).
5. Connect harness assembly (3) to fuel temperature
sensor (2).
6. Turn the fuel supply to the ON position.
180 UENR0624-03
Disassembly and Assembly Section
This document has been printed from SPI2. NOT FOR RESALE