Disassembly and assembly

Illustration 323 g02673736
1. Install a new O-ring seal (4) onto engine oil
pressure switch (3).
2. Install engine oil pressure switch (3) to oil filter
head (1).
3. Using a deep socket tighten the oil pressure switch
to a torque of 25 N·m (221 lb in).
4. Connect harness assembly (2) to engine oil
pressure switch (3).
i05282736
Fuel Temperature Sensor -
Remove and Install
Removal Procedure
Table 73
Required Tools
Tool Part Number
Part Description Qty
A T412504
Capping Kit
1
Contact with high pressure fuel may cause fluid
penetration and burn hazards. High pressure fuel
spray may cause a fire hazard. Failure to follow
these inspection, maintenance and service in-
structions may cause personal injury or death.
NOTICE
Ensure that all adjustments and repairs that are
carried out to the fuel system are performed by
authorized personnel that have the correct
training.
Before beginning ANY work on the fuel system,
refer to Operation and Maintenance Manual,
“General Hazard Information and High Pressure
Fuel Lines” for safety information.
Refer to System Operation, Testing and Adjust-
ing, “Cleanliness of Fuel System Components”
for detailed information on the standards of
cleanliness that must be observed during ALL
work on the fuel system.
NOTICE
Care must be taken to ensure that fluids are con-
tained during performance of inspection, mainte-
nance, testing, adjusting and repair of the product.
Be prepared to collect the fluid with suitable contain-
ers before opening any compartment or disassem-
bling any component containing fluids.
Dispose of all fluids according to local regulations
and mandates.
NOTICE
Keep all parts clean from contaminants.
Contaminants may cause rapid wear and shortened
component life.
1. Turn the fuel supply to the OFF position.
2. Turn the battery disconnect switch to the OFF
position.
UENR0624-03 179
Disassembly and Assembly Section
This document has been printed from SPI2. NOT FOR RESALE