Disassembly and assembly

Illustration 317 g02672140
1. Install a new O-ring seal (5) to camshaft position
sensor (3).
2. Install camshaft position sensor (3) to front cover
(2). Ensure that the camshaft position sensor is
correctly orientated.
3. Apply Tooling (A) onto the threads of bolt (1).
Install bolt (1) to the camshaft position sensor.
Tighten the bolt to a torque of 10 N·m (89 lb in)
4. Connect harness assembly (4) to camshaft
position sensor (3). Slide the locking tab into the
locked position.
i05282713
Crankshaft Position Sensor -
Remove and Install
Removal Procedure
NOTICE
Keep all parts clean from contaminants.
Contaminants may cause rapid wear and shortened
component life.
Illustration 318 g02673817
1. Slide the locking tab into the unlocked position.
Disconnect harness assembly (2) from crankshaft
position sensor harness (1).
2. Cut cable strap (6).
3. Remove bolt (3) from the cylinder block.
4. Carefully remove crankshaft position sensor (5)
from the cylinder block.
Note: Do not use a lever to remove the crankshaft
position sensor from the cylinder block.
5. Remove O-ring seal (4) (not shown) from
crankshaft position sensor (5).
Installation Procedure
NOTICE
Keep all parts clean from contaminants.
Contaminants may cause rapid wear and shortened
component life.
176 UENR0624-03
Disassembly and Assembly Section
This document has been printed from SPI2. NOT FOR RESALE