Disassembly and assembly

Note: When Tooling (A) is used, the readings can
sometimes be unclear. For example, all parts of
Tooling (A) are not the same width. Measure the
major width in order to ensure that the parts are
within the specification range. Refer to Specifications
Manual, “Connecting Rod Bearing Journal” and
Specifications Manual, “Main Bearing Journal” for the
correct clearances.
i05282685
Camshaft Position Sensor -
Remove and Install
Removal Procedure
NOTICE
Care must be taken to ensure that fluids are con-
tained during performance of inspection, mainte-
nance, testing, adjusting and repair of the product.
Be prepared to collect the fluid with suitable contain-
ers before opening any compartment or disassem-
bling any component containing fluids.
Dispose of all fluids according to local regulations
and mandates.
NOTICE
Keep all parts clean from contaminants.
Contaminants may cause rapid wear and shortened
component life.
Illustration 316 g02672140
1. Slide the locking tab into the unlocked position and
disconnect harness assembly (4) from camshaft
position sensor (3).
2. Remove bolt (1). Carefully remove camshaft
position sensor (3) from front cover (2).
Note: Do not use a lever to remove the camshaft
position sensor. Make a note of the orientation of the
camshaft position sensor for installation purposes.
3. Remove O-ring seal (5) from camshaft position
sensor (3).
Installation Procedure
Table 72
Required Tools
Tool Part Number
Part Description Qty
A
-
Loctite 506 1
NOTICE
Keep all parts clean from contaminants.
Contaminants may cause rapid wear and shortened
component life.
UENR0624-03 175
Disassembly and Assembly Section
This document has been printed from SPI2. NOT FOR RESALE