Disassembly and assembly

Illustration 313 g03010798
1. Support crankshaft (4) on a suitable stand.
2. Remove Torx screws (1) from crankshaft timing
ring (2). Do not reuse the Torx screws.
3. Carefully remove crankshaft timing ring (2) from
crankshaft (4).
Note: Ensure that the seal surface on adaptor (5) is
not damaged when the crankshaft timing ring is
removed.
Note: Do not remove dowel (3) from the crankshaft
unless the dowel is damaged.
Installation Procedure
NOTICE
Keep all parts clean from contaminants.
Contaminants may cause rapid wear and shortened
component life.
1. Ensure that the teeth of the crankshaft timing ring
are clean and free from damage.
2. Support crankshaft (4) on a suitable stand.
Illustration 314 g03010798
3. If dowel (3) was removed, install a new dowel to
crankshaft (4).
4. Position crankshaft timing ring (2) onto the
crankshaft with the chamfer toward the crankshaft
web. Align the hole in crankshaft timing ring with
dowel (3) in the crankshaft. Carefully install the
crankshaft timing ring to the crankshaft.
Note: Ensure that the seal surface on adaptor (5) is
not damaged when the crankshaft timing ring is
installed.
5. Install new Torx screws (1). Tighten the Torx
screws to a torque of 10 N·m (89 lb in).
End By:
a. Install the crankshaft. Refer to Disassembly
and Assembly, “Crankshaft - Install ” for the
correct procedure.
i05980323
Bearing Clearance - Check
Measurement Procedure
Table 71
Required Tools
Tool Part Number
Part Description Qty
(continued)
UENR0624-03 173
Disassembly and Assembly Section
This document has been printed from SPI2. NOT FOR RESALE