Disassembly and assembly

ManualsBrandsPerkins Engine ManualsOther854F-E34T, 854E-E34TA, 854F-E34TA Disassembly and Assembly

171

172

173

174

175

176

177

178

179

180

5. If necessary, remove the crankshaft timing ring (1).

Refer to Disassembly and Assembly, “Crankshaft

Timing Ring - Remove and Install” for the correct

procedure.

i05282673

Crankshaft - Install

Installation Procedure

Table 70

Required Tools

Tool Part Number

Part Description Qty

Lifting Sling

21825617 Dial Indicator 1

Magnetic Base and Stand

NOTICE

Keep all parts clean from contaminants.

Contaminants may cause rapid wear and shortened

component life.

1. Clean the crankshaft and inspect the crankshaft for

wear and damage. Refer to Specifications,

“Crankshaft” for more information. If necessary,

replace the crankshaft or recondition the

crankshaft.

Illustration 312 g03008302

2. If necessary, install a new crankshaft timing ring

(1). Refer to Disassembly and Assembly,

“Crankshaft Timing Ring - Remove and Install” for

the correct procedure.

3. Ensure that parent bores for bearing shells in the

cylinder block are clean. Ensure that the threads

for the main bearing bolts in the cylinder block are

clean and free from damage.

4. Clean the main bearing shells and the thrust

washers. Inspect the main bearing shells and the

thrust washers for wear and damage. If necessary,

replace the main bearing shells and the thrust

washers.

Note: If the main bearing shells are replaced, check

whether oversize main bearing shells were

previously installed. If the thrust washers are

replaced, check whether oversize thrust washers

were previously installed.

5. Install upper main bearing shells to the cylinder

block. Refer to Disassembly and Assembly,

“Crankshaft Main Bearings - Remove and Install”

for the correct procedure.

Note: The upper main bearing shells have a groove

and an oil hole.

6. Lubricate upper main bearing shells with clean

engine oil.

7. Attach Tooling (A) and a suitable lifting device to

crankshaft (2). Lift the crankshaft into the cylinder

block. The weight of the crankshaft is

approximately 35 kg (77 lb).

UENR0624-03 171

Disassembly and Assembly Section

This document has been printed from SPI2. NOT FOR RESALE