Disassembly and assembly

Illustration 25 g03011036
5. Remove the plugs from the plastic tube
assemblies. Remove the caps from the ports in
the fuel filter base.
NOTICE
Ensure that the plastic tube assemblies are installed
in the original positions. Failure to connect the plastic
tube assemblies to the correct ports will allow con-
tamination to enter the fuel system. Allowing contami-
nation to enter the fuel system will cause serious
damage to the engine.
6. Connect plastic tube assembly (1) and plastic tube
assembly (2) to the fuel filter base.
7. Connect harness assembly (5) to fuel temperature
sensor (4). Slide locking tab in to the lock position.
8. Turn the fuel supply to the ON position.
9. Turn the battery disconnect switch to the ON
position.
End By:
a. Remove the air from the fuel system. Refer to
Operation and Maintenance Manual, “Fuel
System - Prime” for the correct procedure.
i05268272
Water Separator and Fuel
Filter (Primary) - Remove and
Install
Removal Procedure
Table 4
Required Tools
Tool Part Number
Part Description Qty
A
T412504
Capping Kit
1
NOTICE
Ensure that all adjustments and repairs that are
carried out to the fuel system are performed by
authorized personnel that have the correct
training.
Before beginning ANY work on the fuel system,
refer to Operation and Maintenance Manual,
“General Hazard Information and High Pressure
Fuel Lines” for safety information.
Refer to System Operation, Testing and Adjust-
ing, “Cleanliness of Fuel System Components”
for detailed information on the standards of
cleanliness that must be observed during ALL
work on the fuel system.
1. Turn the battery disconnect switch to the OFF
position.
2. Turn the fuel supply to the OFF position.
UENR0624-03 17
Disassembly and Assembly Section
This document has been printed from SPI2. NOT FOR RESALE