Disassembly and assembly

End By:
a. Install the cylinder head. Refer to Disassembly
and Assembly, “Cylinder Head - Install” for the
correct procedure.
b. If necessary, install the balancer. Refer to
Disassembly and Assembly, “Balancer -
Install” for the correct procedure.
c. Install the oil suction pipe. Refer to
Disassembly and Assembly, “Engine Oil Pan
Remove and Install” for the correct procedure.
i05282665
Connecting Rod Bearings -
Remove
(Connecting rods in position)
Removal Procedure
Start By:
a. Remove the engine oil suction pipe. Refer to
Disassembly and Assembly, “Engine Oil Pan -
Remove and Install” for the correct procedure.
b. If necessary, remove the balancer. Refer to
Disassembly and Assembly, “Balancer -
Remove ” for the correct procedure
NOTICE
Keep all parts clean from contaminants.
Contaminants may cause rapid wear and shortened
component life.
NOTICE
Discard all used Connecting Rod fasteners.
Note: If all connecting rod bearings require
replacement, the procedure can be carried out on
two cylinders at the same time. The procedure can
be carried out on the following pairs of cylinders. 1
and 4 then 2 and 3. Ensure that the installation
procedure on one pair connecting rods is
completed before starting the removal procedure
on the next pair of connecting rods.
Illustration 299 g03005637
(X) Identification marks
Illustration 300 g01341322
1. The connecting rod and the connecting rod cap
should have an etched number in Positions (X).
The number on the connecting rod and the
connecting rod cap must match. If necessary,
make a temporary mark on connecting rod (5) and
connecting rod cap (2) in order to identify the
cylinder number.
Note: Do not punch identification marks onto fracture
split connecting rods. Do not stamp identification
marks onto fracture split connecting rods.
2. Rotate the crankshaft so that required connecting
rods are at bottom center position. Remove bolts
(1) and discard the bolts.
3. Remove connecting rod cap (2) from connecting
rod (5).
164 UENR0624-03
Disassembly and Assembly Section
This document has been printed from SPI2. NOT FOR RESALE