Disassembly and assembly

When M10 bolts are installed, tighten bolts (6) to a
torque of 45 N·m (33 lb ft).
15. Remove Tooling (B) from Position (Z) in the
balancer.
16. Remove Tooling (A) from Position (X) in the
cylinder block.
17. Install a new O-ring seal (1) to plug (2). Install
plug (2) into Position (X) in the cylinder block.
Tighten the plug to a torque of 50 N·m (37 lb ft).
End By:
a. Install the engine oil pan. Refer to Disassembly
and Assembly, “Engine Oil Pan - Remove and
Install” for the correct procedure.
i05279052
Piston Cooling Jets - Remove
and Install
Removal Procedure
Start By:
a. Remove the engine oil pan. Refer to
Disassembly and Assembly, “Engine Oil Pan -
Remove and Install” for the correct procedure.
b. Remove the crankshaft. Refer to Disassembly
and Assembly, “Crankshaft - Remove” for the
correct procedure.
NOTICE
Keep all parts clean from contaminants.
Contaminants may cause rapid wear and shortened
component life.
Illustration 288 g02895676
1. Remove banjo bolt (2) and piston cooling jet (1)
from the cylinder block.
2. Repeat Step 1 in order to remove the remaining
piston cooling jets.
Installation Procedure
NOTICE
Keep all parts clean from contaminants.
Contaminants may cause rapid wear and shortened
component life.
UENR0624-03 157
Disassembly and Assembly Section
This document has been printed from SPI2. NOT FOR RESALE