Disassembly and assembly

11. Ensure that the face of engine oil pan (3) and the
cylinder block are still correctly aligned.
12. Install a new sealing washer (5) to oil drain plug
(6).
13. Install oil drain plug (6) to the engine oil pan .
Tighten the oil drain plug to a torque of 50 N·m
(37 lb ft).
14. Remove the engine from the suitable stand.
15. Fill the engine oil pan to the correct level. Refer to
Operation and Maintenance Manual, “Engine Oil
and Filter - Change” for the correct procedure.
i05279046
Balancer - Remove
Removal Procedure
Table 60
Required Tools
Tool Part Number Part Name
Qty
A T400086
Crankshaft Locking Pin
1
B
-
Balancer Timing Pin
(Bolt M8 by 22mm)
1
Start By:
a. Remove the engine oil pan. Refer to
Disassembly and Assembly, “Engine Oil Pan -
Remove and Install” for the correct procedure.
Note: In order to remove the balancer safely, the
engine must be removed from the machine. The
engine should be mounted in a suitable stand and
placed in the inverted position.
NOTICE
Keep all parts clean from contaminants.
Contaminants may cause rapid wear and shortened
component life.
NOTICE
Care must be taken to ensure that fluids are con-
tained during performance of inspection, mainte-
nance, testing, adjusting and repair of the product.
Be prepared to collect the fluid with suitable contain-
ers before opening any compartment or disassem-
bling any component containing fluids.
Dispose of all fluids according to local regulations
and mandates.
Illustration 282 g02887016
Illustration 283 g02709625
154 UENR0624-03
Disassembly and Assembly Section
This document has been printed from SPI2. NOT FOR RESALE