Disassembly and assembly

Illustration 280 g02835539
Initial tightening sequence
Illustration 281 g02835357
Secondary tightening sequence
4. Position gasket (1) (not shown) onto engine oil pan
(4).
5. Attach a suitable lifting device to engine oil pan (3).
The engine oil pan can weigh 45 kg (99 lb).
6. Use the lifting device in order to position engine oil
pan (3) onto the cylinder block.
7. Apply Tooling (A) to bolts (4).Install the bolts finger
tight.
8. Align the rear face of the engine oil pan with the
rear of the cylinder block.
9. Tighten bolts (4) in the initial sequence that is
shown in Illustration 280 .
Tighten bolts (7) to a torque of 45 N·m (33 lb ft).
10. Tighten bolts (4) in the final sequence that is
shown in Illustration 281 .
Tighten bolts (7) to a torque of 45 N·m (33 lb ft).
UENR0624-03 153
Disassembly and Assembly Section
This document has been printed from SPI2. NOT FOR RESALE