Disassembly and assembly

Illustration 278 g02835177
Typical example
2. If necessary, follow Step 2.a through Step 2.f in
order to install oil suction pipe (8).
a. Install new O-ring seal (7) to oil suction pipe (8).
b. Install the oil suction pipe to the cylinder block.
c. Apply Tooling (A) onto the threads of Allen head
cap screw (9). Install the Allen head cap screw
to the oil suction pipe.
d. Apply Tooling (A) onto the threads of bolts (10).
Install bolts (10) to the oil suction pipe support.
e. Tighten Allen head cap screw (9) to a torque of
10 N·m (89 lb in).
f. When M8 bolts are installed, tighten bolts (10)
to a torque of 25 N·m (221 lb in).
When M10 bolts are installed, tighten bolts
(10) to a torque of 45 N·m (33 lb ft).
3. Clean the mating surface of the cylinder block.
Illustration 279 g02835137
152 UENR0624-03
Disassembly and Assembly Section
This document has been printed from SPI2. NOT FOR RESALE