Disassembly and assembly

Illustration 274 g02823478
Illustration 275 g02826556
4. Position gasket (1) (not shown) onto engine oil pan
(4).
5. Position spacer (2) onto the engine oil pan.
6. Position engine oil pan assembly (4) onto the
cylinder block. Use a suitable tool to support the
weight of the engine oil pan.
7. Install bolts (3) and install bolts (7) finger tight.
8. Tighten bolts (3) and bolts (7) in the sequence that
is shown in Illustration 275 .
Tighten bolts (3) to a torque of 25 N·m (221 lb in).
Tighten bolts (7) to a torque of 45 N·m (33 lb ft).
9. Install a new sealing washer (5) to oil drain plug
(6).
10. Install oil drain plug (6) to the engine oil pan .
Tighten the oil drain plug to a torque of 50 N·m
(37 lb ft).
11. Fill the engine oil pan to the correct level. Refer to
Operation and Maintenance Manual, “Engine Oil
and Filter - Change” for the correct procedure.
i05279039
Engine Oil Pan - Remove and
Install
(Cast Iron Engine Oil Pan)
Removal Procedure
NOTICE
Keep all parts clean from contaminants.
Contaminants may cause rapid wear and shortened
component life.
NOTICE
Care must be taken to ensure that fluids are con-
tained during performance of inspection, mainte-
nance, testing, adjusting and repair of the product.
Be prepared to collect the fluid with suitable contain-
ers before opening any compartment or disassem-
bling any component containing fluids.
Dispose of all fluids according to local regulations
and mandates.
Note: Ensure that the engine lubricating oil is
drained. Refer to Operation and Maintenance
Manual, “Engine Oil and Filter - Change” for the
correct procedure.
Note: In order to remove a cast iron oil pan, the
engine must be removed from the machine. The
engine should be mounted in a suitable stand and
placed in the inverted position.
150 UENR0624-03
Disassembly and Assembly Section
This document has been printed from SPI2. NOT FOR RESALE