Disassembly and assembly

Illustration 21 g03011037
10. Remove cannister (8) from fuel filter base (3).
Remove secondary filter (7). Refer to Operation
and Maintenance Manual, “Fuel System
Secondary Filter - Replace” for the correct
procedure.
11. Remove nuts (6) from fuel filter base (3). Remove
the fuel filter base from the mounting bracket.
Note: Do not disassemble the fuel filter base.
Illustration 22 g03011038
12. If necessary, follow Step 1.c through Step 12.c in
order to remove the bracket for secondary fuel
filter.
a. Remove bolts (11) fuel filter bracket (10).
b. Remove fuel filter bracket (10) from the valve
mechanism cover.
c. If necessary, remove studs (9). from fuel filter
bracket (10).
Installation Procedure
NOTICE
Ensure that all adjustments and repairs that are
carried out to the fuel system are performed by
authorized personnel that have the correct
training.
Before beginning ANY work on the fuel system,
refer to Operation and Maintenance Manual,
“General Hazard Information and High Pressure
Fuel Lines” for safety information.
Refer to System Operation, Testing and Adjusting
, “Cleanliness of Fuel System Components” for
detailed information on the standards of cleanli-
ness that must be observed during ALL work on
the fuel system.
NOTICE
Ensure that the wiring harness assembly is correctly
routed and the cable straps are not over tightened.
Over tightening of the cable straps will damage the
wiring harness and the convoluting.
UENR0624-03 15
Disassembly and Assembly Section
This document has been printed from SPI2. NOT FOR RESALE