Disassembly and assembly

Illustration 272 g02823476
7. If necessary, follow Step 7.a through Step 7.d in
order to remove oil suction pipe (9) from the
cylinder block.
a. Remove Allen head cap screw (10) from oil
suction pipe (9).
b. Remove bolts (11) from oil suction pipe (9).
c. Remove oil suction pipe (9) from the cylinder
block.
d. Remove O-ring (8) from oil suction pipe (9).
Installation Procedure
Table 58
Required Tools
Tool Part Number
Part Description Qty
A
-
Technologic 15
1
NOTICE
Keep all parts clean from contaminants.
Contaminants may cause rapid wear and shortened
component life.
1. Ensure that all components are clean and free
from damage. If necessary, replace any
components that are worn or damaged.
Illustration 273 g02823476
2. If necessary, follow Step 2.a through Step 2.f in
order to install oil suction pipe (9).
a. Install new O-ring seal (8) to oil suction pipe (9).
b. Install oil suction pipe (9) to the cylinder block.
c. Apply Tooling (A) onto the threads of Allen head
cap screw (10). Install the Allen head cap screw
to the oil suction pipe.
d. Apply Tooling (A) onto the threads of bolts (11).
Install bolts (11) to the oil suction pipe support.
e. Tighten Allen head cap screw (10) to a torque of
10 N·m (89 lb in).
f. When a M8 bolts are installed, tighten bolts (11)
to a torque of 25 N·m (221 lb in).
When a M10 bolts are installed, tighten bolts
(11) to a torque of 45 N·m (33 lb ft).
3. Clean the mating surface of the cylinder block.
UENR0624-03 149
Disassembly and Assembly Section
This document has been printed from SPI2. NOT FOR RESALE